How to adjust the correction and tightening of the filter belt of the belt filter press

          The operation of the filter belt must be kept as symmetrical as possible in the middle of the rollers. This machine adopts sensitive pneumatic component sensors to detect and control. When the filter belt deflects laterally, the correction cylinder drives one end of the correction roller to advance or retreat to ensure the upper and lower sides. The maximum offset of the next two mesh belts does not exceed 30mm. It adopts sensitive pneumatic component sensor detection and control, with large detection angle and buffering ability, so that the two mesh belts and the running process are always in a monitored state, and the control position is accurate, which completely solves the problem of the sudden contact or pressure of the conventional correction switch with the mesh belt. When the sliding arm or chute of the travel switch slips off at a large time, the mesh belt is out of control and shifts and causes frequent emergency stop failures, which further guarantees the reliability and stability of the main engine operation. The new type of proximity switch equipped with this machine to correct deviation after exceeding the limit The monitoring system, excellent performance, domestic first, so that the belt filter press can run continuously without failure, and the running time is increased by more than 3.5 meters.

The correction roller adopts a special design double correction cylinder. This is the company’s careful reference to international models. As a result of the transformation, when the mesh belt is running normally, the correcting roller can be kept at the parallel middle position; when the mesh belt is laterally deflected, the cylinder at the corresponding end will follow the action to make the mesh belt return to the middle position of the roller smoothly, which improves The old-fashioned correction system with a correction cylinder set only at one end. The correcting roller is always in the extreme motion posture, and the twisting caused to the mesh belt is reduced, thereby reducing the degree of damage to the mesh belt.

         Doyen specializes in providing belt press equipment for the Southeast Asian market. Welcome to visit our workshop and formulate a more scientific  plan based on the actual situation of your company. Welcome to visit joyce@doyenchina.com or visit https://www.doyenchina.com.