How does the sludge filter press mud mixer meet the production requirements

        The mud mixer of the sludge filter press adopts a speed regulating device, which meets the requirements of the working conditions. The main transmission variable speed worm changes the force direction and the force is reasonable. A rectifying roller is placed under the filter cloth, which can more effectively correct the filter cloth. The wedge-shaped mud inlet reduces two auxiliary shaft rollers. After the reduction, it is convenient for the installer to adjust, but it will not affect the daily extrusion and dewatering operation.

The rear frame adopts the upper inclined beam to change the fixed bolt connection. It is easy to adjust and repair the rollers. The left and right sides of the main drive shaft adopt movable support plates for easy installation and maintenance.

The additional exhaust hood improves the indoor working environment. At the same time, a single screw pump is used as a mud pump, which can adjust the speed and adjust the speed. The machine is equipped with reasonable equipment, the pneumatic system is made of good quality manufacturers, the tension filter cloth is stable and reliable, the tension is uniform, the correction system is flexible and effective, and the air pressure sensor can ensure the stable operation of the equipment, which is convenient for the user to operate later.

The continuous operation of the dewatering operation of the sludge filter press, the correction of the filter belt and the tensile strength, wrinkle resistance, and abrasion resistance are discussed in terms of the influence of the filter material and the organization method. The working pressure of the tensioning cylinder is 6kgf/ cm2, the working pressure during normal operation is about 4kgf/cm2, and the working pressure of the correction cylinder should be about 3kgf/cm2. Therefore, the material of the filter is required to have high tensile strength and small deformation, and the organization must be tight. Net, because polypropylene fiber has low elasticity, that is, its deformation under unit pressure is large, so it is not suitable for use in equipment with high tension pressure.

Polyamide fiber has high elasticity, good resilience and abrasion resistance. It is high in fiber, has multiple deformation resistance and fatigue resistance close to polyester fiber, higher than other chemical fibers, and has good moisture absorption. It can also be used in many occasions.

         Doyen specializes in providing belt press equipment for the Southeast Asian market. Welcome to visit our workshop and formulate a more scientific  plan based on the actual situation of your company. Welcome to visit joyce@doyenchina.com or visit https://www.doyenchina.com.